To center your brake caliper:
1. Loosen the 2 bolts shown below so that they're hand tight
2. Firmly press the brake lever of the caliper you are adjusting
3. While holding the brake lever, tighten the two hand tight bolts
4. This should ensure your caliper is as centered as possible on the brake rotor to prevent drag
Related to:
1
-1
Was this article helpful?
0 out of 1 found this helpful
Articles in this section
- SOP: Help us Help you - A useful guide to streamline support and resolution
- TruMoto App & Controller Troubleshooting Guide
- ETM RTR / ETM RTR Lite / RTR XL / RTR Alpha / Rizzler Troubleshooting Guide
- Controller, Throttle, and Harness Safety Triage
- Customer Battery Troubleshooting and Safety Guide
- Troubleshooting your 12v DCDC / Headlight Kit
- My bike chain keeps breaking at the master link
- How do I replace the brake lever on my ETM RTR?
- How to center your brake caliper on your brake rotor
- How do I remove the motor from my ETM RTR?
Add comment
Article is closed for comments.