The DKD Display includes a settings menu for adjusting units, wheel parameters, battery voltage, and other display functions.
Access the settings menu
- Turn on the display and wait for the startup self-test to finish.
- Press and hold the left button for 10 seconds to enter the settings menu.
- Enter the password for the setting you want to adjust.
Use the buttons as follows:
- Left button: Change the selected value.
- Right button: Move to the next digit or field.
Settings and passwords
| Password | Setting | Details |
|---|---|---|
| 153 | Wheel and motor parameters | Adjust the wheel circumference in millimeters, motor pole pairs, and offset. The listed default circumference is 1431 mm for an 18-inch tire. Press and hold the right button to access the motor pole-pair and offset settings. The listed defaults are 24 pole pairs and 10 offset. |
| 256 | Gear display mode | Select high/low gear display (E/S) or normal gear display. 2 selects high/low gear display; 0 selects normal gear display. |
| 372 | Reset odometer | Clear the total distance (ODO). The supplied instructions state that this function is limited to three uses. |
| 856 | Battery voltage selection | Select 48V, 60V, or 72V for the battery-level indicator. The supplied instructions describe automatic lithium-battery state-of-charge detection and switching. After changing the battery, turn the display off and back on. |
| 879 | Preset voltage calibration | Select the calibration corresponding to a 48V, 60V, or 72V battery. |
| 824 | Manual voltage calibration | Enter a voltage calibration value manually. |
| 974 | Speed and distance units | Switch between km/h and mph. |
| 928 | D/N indicator settings | Configure or disable the D and N indicator lights. |
| 919 | Voltage thresholds | Adjust the overvoltage and undervoltage values. The first value is overvoltage; the second is undervoltage. |
Before changing settings
Record the existing values before making adjustments. Wheel circumference and motor pole-pair settings should match your vehicle’s specifications. Battery voltage and voltage thresholds should match the installed battery.
This is an awesome video that one of our customers made to guide you through a basic function tuning HERE.
0
0
Was this article helpful?
0 out of 0 found this helpful
Articles in this section
- RTR Alpha User Guide
- ETM RTR XL User Guide
- ETM RTR Sport User Guide
- ETM RTR User Guide
- ETM RTR Lite User Guide
- Rizzler User Guide
- How to Upgrade Your 60V Rizzler: The Best Builds for Power, Range, Dirt and Stunts
- How to Upgrade Your Razor MX650 or SX500: The Complete Electro & Company Guide
- How Should I Upgrade My ETM RTR Sport?
- How Should I Upgrade My ETM RTR Lite?
Add comment
Article is closed for comments.